|
|
 |
| |
Available Pictures | Available Videos
|
| This is our Progessive EMS controller. Its important to download the PDF to make sure you understand how this works. You must have an EMS or piggyback that has the necessary hardware to run this. Basically you program your EMS to send a frequency based dutycycle (5 volt) to the small orange wire. The frequency must be anywhere from 1 to 1000 hz. If your PWM output from your EMS is ground switched you will need to use a resistor and 5V source. See our PDF for details. This progressive failsafebox will then run the system at the DC your EMS is programmed. By doing this, you progressively control the water/meth system with your EMS using this controller. This listing is for just the controller, if you need the entire kit see our EMS Kit. You can upgrade stage 1 kits with this controller as well. This controller is very small. About 1.25 inch long and about 1 inch wide. |
|
|
|
|